Sale!

MATEK ELRS R24 TD Drone ExpressLRS ELRS 2.4GHz Receiver

Mateksys MATEK ELRS-R24-TD UAV Drone ExpressLRS ELRS 2.4GHz True Diversity Receiver Module for RC FPV Multirotor Airplane Fixed-wing Drones FC Flight Controller|1Pcs

Name: Mateksys MATEK ELRS-R24-TD UAV Drone ExpressLRS ELRS 2.4GHz True Diversity Receiver Module for RC FPV Multirotor Airplane Fixed-wing Drones FC Flight Controller|1Pcs
SKU: ELRS-R24-TD
Availability: InStock

Original price was: $29.00.Current price is: $27.55.

1PCS Mateksys MATEK ELRS-R24-TD UAV Drone ExpressLRS ELRS 2.4GHz True Diversity Receiver Module for RC FPV Multirotor Airplane Fixed-wing Drones FC Flight Controller

SKU: ELRS-R24-TD Category: UAV Drone

Description

Mateksys MATEK ELRS-R24-TD UAV Drone ExpressLRS ELRS 2.4GHz True Diversity Receiver Module for RC FPV Multirotor Airplane Fixed-wing Drones FC Flight Controller

Feature

1.Specifications:

ESP32-PICO-D4, SX1281, ExpressLRS Firmware
PA/LNA: AT2401C
RF Frequency: 2.4GHz ISM
Telemetry power: 20dbm (100mW)
True Diversity
Receiver protocol: CRSF
Antenna connector: IPEX MHF-1
Power supply: 4-13V DC @ “V” Pad
Power dissipation: 100mA~170mA@5V IN

2.Firmwares:

ExpressLRS, wiki, Click HERE

3.RGB LED Status:

[Rainbow fade effect], Starting Up
[Green heartbeat], Web update mode enabled
[Slow blink 500ms on/off ], Waiting for connection from transmitter
[Red flashing 100ms on/off], Radio chip not detected
[Orange Double blink then pause], Binding mode enabled
[Orange Triple blink then pause], Connected to transmitter but mismatched model-match configuration
[Solid single color Connected to a transmitter], color indicates packet rate
in Boot mode, RGB LED doesn’t light up.

4.Flashing via Wifi:

Power on receiver. RGB LED Rainbow fade effect at first, then Slow blink 500ms on/off. after 20s, Green blink indicating it’s on Wifi Hotspot Mode.
Wifi SSID “ExpressLRS RX”, Password “expresslrs”
More detailed steps, pls refer this page.

5.Flashing via UART

Wire the receiver into the USB-TTL adapter, with TX on receiver connected to the Rx on the USB-TTL, and RX on receiver connected to the Tx of the USB-TTL. Wire 5V and GND of the USB-TTL to 5V and GND of the Receiver.
Press the boot button while powering on the receiver, then release – the RGB LED will not turn on.
In Configurator, Select the target Generic ESP32 True Diversity PA 2.4Ghz RX, or RadioMaster RP4-TD, or HappyModel EP Dual and “UART” for Flashing Method, set your bind phrase and Firmware Options , Check “erase before flash” and “Force FLash “.
Web-flasher https://expresslrs.github.io/web-flasher/.

6.Tips

Full Resolution Switch Configuration Modes
Powering receiver with Reverse Voltage will damage the regulator chip. DOUBLE CHECK the power wires connected to the receiver.

Mechanical

1.Physical: