Description
MATEK Mateksys PDB FCHUB-12S V2 5V 12V Output Current-Sensor 440A 3-12S LiPo Drone Power Distribution Board for RC FPV FC
Feature
1.Input voltage range: 8~60V (3~12S LiPo);
2.4x70A cont, 4x110A burst;
3.4x ESC power /signal/ telemetry pads;
4.Current Senor: 440A, 3.3V ADC, Scale 75;
5.2x LED indicators for 5V, 12V;
6.1K:20K voltage divider built-in;
2.4x70A cont, 4x110A burst;
3.4x ESC power /signal/ telemetry pads;
4.Current Senor: 440A, 3.3V ADC, Scale 75;
5.2x LED indicators for 5V, 12V;
6.1K:20K voltage divider built-in;
7.JST-SH 8pin connector;
8.“V” pad: 12V or VBat voltage selectable;
9.G: GND;
10.Curr: current sensor signal;
11.TLM: for BlHeli32 ESC telemetry;
12.S1~S4: ESC signal;
8.“V” pad: 12V or VBat voltage selectable;
9.G: GND;
10.Curr: current sensor signal;
11.TLM: for BlHeli32 ESC telemetry;
12.S1~S4: ESC signal;
Electrical
1.BEC 5V output (5V pad);
2.Voltage: 5.1 +/- 0.1VDC;
3.Continuous current 5 Amps, Max.6A;
4.Short-circuit tolerant (2 seconds);
5.Overcurrent protection & self-recovery;
6.BEC 12V output (12V pad);
7.Voltage: 12.0 +/- 0.2VDC (Input voltage >=12V);
8.Continuous current 4 Amps, Max.5A;
9.Input voltage<12V, Output voltage = Input voltage;
10.Short-circuit tolerant (2 seconds);
11.Overcurrent protection & self-recovery;
8.Continuous current 4 Amps, Max.5A;
9.Input voltage<12V, Output voltage = Input voltage;
10.Short-circuit tolerant (2 seconds);
11.Overcurrent protection & self-recovery;
12.Switchable 12V output (12VSW pad);
13.12V ON/OFF switchable via PINIO(high/low level);
14.support constant 2A;
14.support constant 2A;
15.can be use for powering VTX,LED etc.;
16.BEC 3.3V output;
17.Linear Regulator;
18.Continuous current: 500mA;
Mechanical
1.Mounting: 30.5 x 30.5mm, Φ3mm;
2.Dimensions: 55 x 50 x 6 mm;
3.Weight: 21g;
2.Dimensions: 55 x 50 x 6 mm;
3.Weight: 21g;
4.Including: 1x FCHUB-12S V2 1x SH1.0_8pin cable 5cm, 2x SH1.0_8pin connectors;
Reviews
There are no reviews yet.