Mateksys MATEK ELRS-R24-P6V UAV Drone ExpressLRS ELRS 2.4GHz PWM Vario Receiver Module for RC FPV Multirotor Airplane Fixed-wing Drones FC Flight Controller|1Pcs

Description

• ESP32-PICO-D4, SX1281, ExpressLRS Firmware
  
• PA/LNA: SE2431L
  
• RF Frequency: 2.4GHz ISM
  
• Telemetry power: 22.5dbm (180mW)
  
• Diversity: Antenna-switching, default ANT1
  
• Barometer SPL06-001 (Vario)
  
• Receiver output: 6x PWM CH
  
• VBAT voltage sense: 0~25.5V
  
• Antenna connector: IPEX MHF-1
  
• Power supply: 4-13V DC @ “V” Pad
  
• Power dissipation: 60mA~80mA@5V IN

• ExpressLRS, wiki, Click HERE
  
• Receiver Target: Generic ESP32 PWM Vario 2.4Ghz RX, /or RadioMaster ER6-GV, /or RadioMaster ER6-G
  
• Receiver has ExpressLRS 3.3.2 preloaded with binding phrase “123456”, the Receiver will never enter binding mode if using the traditional binding procedure.
  
• You need to reflash it with your binding phrase OR connect it to your PC/phone via WiFi and set your binding phrase in WebUI.
  

• Power on receiver. Receiver’s LED(Red) will blink slow at first, and after 30s, it should blink fast indicating it’s on Wifi Hotspot Mode.
  
• Wifi SSID “ExpressLRS RX”, Password “expresslrs”
  
• More detailed steps, pls refer this page.

• Disconnect ESC and servos from receiver first.
  
• Wire the receiver into the USB-TTL adapter, with TX(PWM 2 pin) on receiver connected to the Rx on the USB-TTL, and RX(PWM 3 pin) on receiver connected to the Tx of the USB-TTL. Wire 5V and GND of the USB-TTL to “V” and GND of the Receiver.
  
• Press the boot button while powering on the receiver, then release – the Red LED on receiver should now be solid on.
  
• In configurator, Select the target Generic ESP32 PWM Vario 2.4Ghz RX, or RadioMaster ER6-GV and “UART” for Flashing Method, set your bind phrase and Firmware Options , Check “erase before flash” and “Force FLash “.
  
• Web-flasher https://expresslrs.github.io/web-flasher/

• Full Resolution Switch Configuration Modes
  
• Powering receiver with Reverse Voltage will damage the regulator chip. DOUBLE CHECK the power wires connected to the receiver.
  
• Transmitter fw version should be EdgeTX 2.7.1/OpenTX 2.3.15 or newer

---